Aarhus University Seal

Setup for MakerLab

Creality / Elegoo Centauri Carbon - Quick guide for students

How to download OrcaSlicer, select the Centauri Carbon printer, set the 0.4 mm nozzle and choose the correct filament

VERY IMPORTANT - READ BEFORE YOU CONTINUE!

Select ONLY "ELEGOO PETG PRO" as filament during setup and in OrcaSlicer.
PLA, ABS, TPU or other materials must not be selected during the setup phase.

We previously used PLA, but now we only use PETG in MakerLab!

Test file for the course – download it before you arrive

Before the course you must download the test file "Cute Octopus Says Hello". It is the model we print the first time.

Download CuteOcto.stl

"Cute Octopus Says Hello" by MakerBot is licensed under Creative Commons – Attribution (CC BY). The original can be found on Thingiverse.

1) Download OrcaSlicer

OrcaSlicer is the program we use to convert 3D models into G-code that the printer can understand. We recommend downloading it from the official GitHub page or the official OrcaSlicer website.

Download OrcaSlicer

Tip: Avoid random download sites. Use only the official pages to avoid harmful versions of the program.

2) Select the Centauri Carbon printer in OrcaSlicer

Once you have installed OrcaSlicer, you must select the correct printer profile. Follow these steps:

  1. Open OrcaSlicer.
  2. Under Printer Selection→ Elegoo find Elegoo Centauri Carbon.
  3. Select the option "0.4mm nozzle".
  4. Click "Next" to continue.

3) Select the filament "ELEGOO PETG PRO"

Now you must select the correct filament. We have switched plastic type from PLA to PETG. Follow these steps to ensure correct use of the printers:

  1. At Filament type click all so that all checkboxes are deselected.
  2. At Vendor also click all so that all checkboxes are deselected.
  3. Now select PETG under Filament type.
  4. Now select ELEGOO under Vendor.
  5. Some options should appear at the bottom of the window. Select "ELEGOO PETG PRO".
  6. Click "Next" to continue.

Changing filament (quick video guide)

New printers also mean a new way of changing filament. The easiest way is to watch a short video showing how to change the filament on the Centauri Carbon. The video below goes through the whole process:

Short summary:

  • Preheat the nozzle.
  • Use the printer’s Unload function and gently pull the filament out once the nozzle is hot and the printer says it is ready.
  • Cut the tip of the new filament at an angle (about 45°) and feed it into the extruder.
  • Extrude a little (10–20 mm) to make sure the material flows evenly and the colour is correct.
VERY IMPORTANT: Select only ELEGOO PRO PETG in OrcaSlicer under Filament / Print settings.

5) Troubleshooting and safety

  • Never pull or remove filament without preheating – it can damage the extruder.
  • Make sure the spool can rotate freely and that the filament is not stuck.
  • Always check that nozzle and temperature settings match the material.